KLS 7230 N not working after identification angle operation

Home Forums Support KLS 7230 N not working after identification angle operation

This topic contains 0 replies, has 1 voice, and was last updated by  chenglip198 5 days, 6 hours ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #17682

    chenglip198
    Participant

    I am stuck at Identification angle operation at step 8. As told, the beeper beep an error code 3-2 and I will see reset error message in monitor screen of user program. I can hear the beep error giving error 3-2 but the reset error message didn’t not pop out on my screen and my KLS isn’t working even though the identification angle is back to 85 when I turned it on.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.