KLS-H REV and FWD switches

Home Forums Support KLS-H REV and FWD switches

This topic contains 1 reply, has 2 voices, and was last updated by  fanychen1 3 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #8615


    I am finding it difficult to enable these switches no matter what combination of pins i use with the switches on my handlebars. Nothing i seem to do enables or disables them so they both always stay off.




    By default,the controller only needs a reversing switch to change the motor direction.
    FWD switch is not necessary for customers to change the direction.
    If you want to use F-N-R control,you may use pin12(FWD) and pin14(REV)for this function.
    Moreover you may enable three gears switch in the user program.
    The pin12 and pin14 are activated by pin11 12V,not ground signal.
    My email address is sales@kelly-controls.com
    I can send more details about configuration and wiring diagram by email.


Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.